Falmec Down Draft Specifications download pdf (Page 25)

The 4° (4th) speed is timed; if the user does not change the speed, the motor will remain in 4°

(4th) for 7 minutes and then shift into 3° (3rd). The T5 key will switch off and the T4 key will light

up.

6: LIGHT - REMOTE BINDING

Light: Briefly pressing key T6 will turn the light on and off. The T6 key will light up if the light is on. If

the mobile part is closed, it will open, and the light will switch on after a few seconds.

Remote Binding (optional): With motor and light turned off, applying prolonged pressure on the T6 key

will activate remote binding mode. The T6 Key will flash for a maximum of 10 seconds. During

flashing, at least one radio control key must be pressed. The function will deactivate upon

completion of the 10 seconds, or earlier if a compatible remote control is detected.

KEY PRESSURE MANAGEMENT:

Prolonged pressure = finger pressed on key for at least 3 seconds, the function activates during pres-

sure.

Non-prolonged pressure = finger pressed on key for less than 3 seconds, the function activates upon

its release.

Radio control (optional): Place the device far from sources of electromagnetic waves which could

interfere with the range hood’s electronic functions

Maximum operating distance 4 metres. This distance may vary in defect based on electro-

magnetic interference of other devices.

Function of the

remote control

DESCRIPTION

Light Key

Pressing the Light key will switch the light on/off

‘ - ‘ Key

Pressing the ‘-’ Key will decrease motor speed. If 1° (1st) speed is in gear, pressing

the ‘-’ key will turn off the motor

‘ + ‘ Key

If the motor is turned off, pressing the ‘+’ key will activate the motor at 1° (1st)

speed. If the motor is operating, pressing the ‘+’ key will increase motor speed up

to the maximum.

Timer Key

If the motor is active, pressing the timer key will activate/deactivate the timer

function

Code Change

(only in case of

malfunction)

Press the “Luce” (Light) key together with the “Timer” key of the remote control

until the blue LED begins to slowly flash. If the “-” key of the remote control

is pressed within 5 seconds, the new code will be generated and memorised.

Memorisation is confirmed by 3 brief flashes of the LED.

To return to the default code, apply pressure on the “-” key together with the “+”

key for over 5 seconds. Memorisation of the default code will be signalled with 3

brief flashes of the LED.

Each time that a new code is generated or that the default code is set in the

remote control, it is necessary to also carry out the previously described Remote

Binding (Light Key of the pushbutton) procedure.

INSTRUCTIONS FOR REMOVING OR REPLACING

THE FILTERS

1. METAL FILTERS

Open the panel fixed to the body of the range hood with magnets (see ill. H1). To remove

the metal grease-trapping filter (A) pull on the filter handle.

Hoods with perimeter suction:

- Open the panel (see fig. 1). Use handle A to remove the metal grease filter.

English

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 79 80

Comments to this Manuals

No comments

Falmec Down Draft Specifications Page 25

Comments to this Manuals

Related products and manuals for Cooker hoods Falmec Down Draft