Falmec Quasar Top Specifications download pdf (Page 19)

section H1. Then remove the insidel panel (C) acting on the screws V1 (see fig. H1).

At this point, the two filters hooked on the right and left side of the conveyor can be ac-

cessed easily. See the figure for assembly/replacement.

To order new charcoal filters, contact your distributor/dealer.

ONLY FOR ITALY: Download the specific filter order form from the website:

www.falmec.com (access the drop-down assistance menu).

LIGHTING

LED SPOTLIGHT

In this case the hood is equipped with high efficiency, low power LED spotlights with extremely

high durability under normal use conditions.

MAINTENANCE AND CLEANING

Constant maintenance ensures the correct operation and efficiency of the appliance over

time. Special attention should be paid to the metal grease-trapping filters and the charcoal

filters. Frequent cleaning of the filters and their supports will ensure that fats and grease do

not accumulate on the range hood, with the consequent risk of fire.

1. METAL ANTI-GREASE FILTERS AND GREASE DRIP TRAY

Their function is to trap suspended grease particles, accordingly, it is advisable to wash

them once a month in hot water and detergent, without bending them. Leave to dry

completely before re-assembling them.

Oil drip tray: this tray is set up inside the hood under the metal filters with the function of

collecting part of the oil that is not trapped by the metal filters. It is necessary to empty

the tray out at regular intervals, based on use (approximately every 15 days). See the

instructions in point H1 to dismantle and re-assemble the filters and the oil drip tray. We

recommend performing this operation on a regular basis.

2. CHARCOAL FILTERS

These trap the odours present in the stream of air that passes through them. The air is puri-

fied by passing a number of times through the filters and being recirculated into the kitchen.

The charcoal filters cannot be cleaned, and should be replaced on average every 3-4 months

(according to use). To replace the charcoal filters, see the instructions in point H2.

3. CLEANING THE OUTSIDE OF THE APPLIANCE

It is advised to clean the external hood surfaces at least every 15 days in order to avoid that

oily or greasy substances affect the steel surfaces.

The ouside of the range hhod should be cleaned using a damp cloth and neutral liquid

detergent or denatured alcohol.

English

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 75 76

No comments

Falmec Quasar Top Specifications Page 19