Falmec Quasar Top Specifications download pdf (Page 20)

In case of fingerprint-less finish (fasteel) clean only with water and neutral soap using

clean with a soft cloth, rinse and wipe dry thoroughly. Do not use products that contain

abrasive substances, rough cloths or cloths specifically designed for cleaning steel. Using

abrasive substances or rough cloths will inevitably damage the finish of steel. The steel

surface will be irrevocably damaged if the instructions above are not complied with. Keep

these instructions together with the instructions for use of your hood.

The manufacturer accepts no liability for any damage caused by non-compliance with the

instructions above.

4. CLEANING THE INSIDE OF THE APPLIANCE

The electrical parts or parts of the motor assembly inside the range hood must not be

cleaned using liquids or solvents.

Do not use abrasive products.

All the above operations must be performed after having disconnected the appliance from the

mains power supply.

WARRANTY

The new equipment is covered by warranty.

The warranty conditions are provided by the distributor.

The manufacturer is not liable for any inaccuracies in this booklet resulting from printing or

transcription errors. The manufacturer reserves the right to modify its products as it consid-

ers necessary or in the interests of the user, without compromising their essential safety and

operating characteristics.

MOUNTING INSTRUCTIONS, RANGE HOODS

WARNING: Failure to install the screws or fixing device in accordance with these instructions

may result in electrical hazards.

Phase 1

- Place the support bar (A-fig. O2) on the wall, at a height from the cooker resulting from the

sum of the quotas X+518 mm.

- With a spirit level, verify the horizontal alignment and mark 2 drilling points at the ends of the

bar.

- Drill, insert two ø 8mm expansion plugs and fasten the bar with the relative screws.

Phase 2

- Remove the perimeter suction panel, the metal filters and the inside panel (C) according to

the indications in figure H3 and 01.

- Hook the hood to the support bar (fig. O3).

- Adjust the alignment of the hood, using the fixing screws (fig. O3). The upper screw (B)

adjusts the distance from the wall, the lower one (C) the vertical sliding.

Phase 3

- To prevent the hood from falling due to pressure below, fasten it to the wall with an expansion

plug and relative screw using the appropriate holes on the back of the hood (fig. O3).

- For the exhaust version, connect the outlet fittings of the fan to the external exhaust, using a

suitable tube.

- Carry out the electric connection only after having disconnected the electric power supply

of the hood.

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 75 76

Comments to this Manuals

No comments

Falmec Quasar Top Specifications Page 20

Comments to this Manuals

Related products and manuals for Cooker hoods Falmec Quasar Top